<VV> Broken heater cable

Ron ronh at owt.com
Thu Apr 15 18:08:04 EDT 2010


Is there any reason why you can't reset the other end to compensate?
RonH

----- Original Message ----- 
From: "Matt Nall" <patiomatt at aol.com>
To: <virtualvairs at corvair.org>
Sent: Thursday, April 15, 2010 2:23 PM
Subject: Re: <VV> Broken heater cable


>
>
>
> A few have responded that you can rebend the broken wire and put a new 
> loop
> on it.  If you do that you won't get full travel of the cable and you 
> won't
> get much heat.
> Remember the cable at half travel just gives you cold air from the top of
> the turkey roaster thru the 3" hose.  It is only the last half of the 
> travel
> that opens the heat flapper.
> Clark Hartzel
>
> ====================================================
>
>
> Clark,  you cut the housing the same amount.
>
>
> Matt Nall
> Charleston, Oregon
> http://mysite.verizon.net/nalllm
>
>
>
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are 
> the property
> of the writer, please attribute properly. For help, 
> mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America, 
> http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: 
> http://www.vv.corvair.org/mailman/options/virtualvairs
> _______________________________________________ 



More information about the VirtualVairs mailing list