<VV> Master cylinder

[Harry Yarnell]

I think Dennis hit it right; single cylinders seem to bleed just fine on the 
car. duals need to be pre-blead; either on the car with bleeding tubes or in 
a vise.

Harry Yarnell
Perryman Garage and Orphanage
hyarnell1 at earthlink.net
----- Original Message ----- 
From: "Dennis Pleau" <dpleau at wavecable.com>
To: "'Virtual Vairs'" <virtualvairs at corvair.org>
Sent: Thursday, April 29, 2010 3:27 PM
Subject: Re: <VV> Master cylinder


>I never found a reason to bench bleed a single stage master cylinder.  I've
> never been able to get all the air out of dual master without bench
> bleeding.
>
> dp
>
>
>
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are 
> the property
> of the writer, please attribute properly. For help, 
> mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America, 
> http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: 
> http://www.vv.corvair.org/mailman/options/virtualvairs
> _______________________________________________
>