<VV> late rear wheel bearing pressing jig

[Bryan Blackwell]

Yep, we got it.  So, um, is that the direction to use the jig - I'm assuming I would remove the backing plate from the hub and place it in the center, then the yoke goes through the space at the top created where the tops of the four shoes come together?

--Bryan

On May 4, 2010, at 9:38 AM, Harry Yarnell wrote:

> Not sure if I'm posting jpg's properly, but here's a picture (I hope) of the jig I made up to press rear wheel bearings from late models.
> 
> Harry Yarnell
> Perryman Garage and Orphanage
> hyarnell1 at earthlink.net
> -------------- next part --------------
> A non-text attachment was scrubbed...
> Name: rear wheel bearing jig 004.jpg
> Type: image/jpeg
> Size: 136480 bytes
> Desc: not available
> Url : http://www.vv.corvair.org/pipermail/virtualvairs/attachments/20100504/b688c0be/attachment.jpg