<VV> Front spring swap/question on cut springs
sethracer at aol.com
sethracer at aol.com
Wed Apr 20 02:13:29 EDT 2011
All late Corvairs used the spring "rubbers" - but only on the rear coils. The fronts used a rubber bumper over the shaft of the front shock as a last-chance spring addition.
If you lower the front of the car very much, it is worth trimming these a bit before installation.
-Seth
-----Original Message-----
From: Rodney Spooner <rodneyspooner at corvairgarage.com>
To: 'Bryan Blackwell' <bryan at skiblack.com>; sethracer at aol.com
Cc: virtualvairs at corvair.org
Sent: Tue, Apr 19, 2011 7:35 pm
Subject: RE: <VV> Front spring swap/question on cut springs
What the rubber vibration insulator used for the coil spring? Was it on ALL
odel Corvairs, or just the luxurious, top-of-the-line Monzas?
Vairy truly yours,
odney Spooner
iverside, CA 92501
# # #
Bryan Blackwell wrote: " Thanks for the answer to the implied question -
aper the cut end first :-) I guess at that point it doesn't matter which
nd goes up, I'll probably put the 'factory' end on the bottom."
More information about the VirtualVairs
mailing list