<VV> Resistor wire or not?

[Harry Yarnell]

It's inside the engine wiring harness. Cream colored wire with a red (brown)
tracer, if I remember.
This wire is at the third pin at the engine/body connector, and goes to the
yellow/blk (or blk/yel) lead on the starter two pin connector. Short the two
to bypass the resistance wire.

-----Original Message-----
From: virtualvairs-bounces at corvair.org
[mailto:virtualvairs-bounces at corvair.org] On Behalf Of Grant Young
Sent: Sunday, August 28, 2011 2:59 PM
To: virtualvairs at corvair.org
Subject: <VV> Resistor wire or not?

I am installing a Petronix ignition kit into a 1965 140 convertible. The
instructions mention the option of leaving or removing the resistor or wire
(for better performance), if there is one. So, is there one, and if so,
where is it?
Thanks,
Grant
 _______________________________________________
This message was sent by the VirtualVairs mailing list, all copyrights are
the property
of the writer, please attribute properly. For help,
mailto:vv-help at corvair.org
This list sponsored by the Corvair Society of America,
http://www.corvair.org/
Post messages to: VirtualVairs at corvair.org
Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs 
 _______________________________________________