<VV> cam clearance

[Bryan Blackwell]

As I recall, maximum is .003".  If you have a case with only .002" on the front journal (the one next to the gear), it's essentially brand new.

--Bryan

On Jul 9, 2011, at 4:49 PM, AeroNed at aol.com wrote:

> I guess I can't read very well because I can't seem to find the clearance  
> for a LM cam. Any help in finding where that might be located in the shop 
> manual  would be appreciated.
> 
> I have a block with a bit over 2 thousands according to my reading of the  
> Plasti-gage. Is that OK? And yes "a bit" is engineering units....
> 
> Ned