<VV> FLAT TOWING

[BBRT]

You can disconnect the half shaft at both ends. And the outer stub axle will 
turn fine. However, You must fabricate some type of link to hold the outer 
upright/trailing arm vertical (which the half shaft does). In other words, 
you need an upper control arm. It ought to be fastened to the differential 
and on the outer ends, somehow to the stamped metal upright/trailing arm. 
You could weld brackets or maybe drill holes in it and mount flanges you 
make up to attach to your cross piece to each/other side.
Chuck S
----- Original Message ----- 
From: "Trey Bosson" <corvairbo at yahoo.com>
To: <virtualvairs at corvair.org>
Sent: Sunday, March 27, 2011 4:40 PM
Subject: <VV> FLAT TOWING


CAN THE OUTER RACE OF THE HALF-SHAFTS IN 65-69 VAIRS BE SEPERATED FROM THE 
AXLES THEN BE RE-INSERTED IN THE HUB SO THAT ONLY THE WHEEL TURNS AND NOT 
THE DIFFERENTIAL OR TRANSMISSION



 _______________________________________________
This message was sent by the VirtualVairs mailing list, all copyrights are 
the property
of the writer, please attribute properly. For help, 
mailto:vv-help at corvair.org
This list sponsored by the Corvair Society of America, 
http://www.corvair.org/
Post messages to: VirtualVairs at corvair.org
Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs
 _______________________________________________


-----
No virus found in this message.
Checked by AVG - www.avg.com
Version: 10.0.1204 / Virus Database: 1435/3526 - Release Date: 03/24/11