<VV> 1964 Cylinder fit a 1962?

[Mark Durham]

You are correct. I just built a 62 102 into a 64 110 by upgrading to a
110 crank, 64 cylinders, and 64 pistons. Had to notch the YN case a
bit, but the cylinders are the same fit accept the notch. Mark Durham

On Sun, May 15, 2011 at 3:50 PM, Doug Mackintosh
<dougmackintosh at yahoo.com> wrote:
> I think the 1964 cylinders are the same as the 1962, except for the clearance
> notches for the longer crank throw. I believe the length from the base gasket
> surface to the head gasket surface is the same. I think the stroke difference is
> handled by a different distance from piston top to wrist pin. In that case, I
> could use a 1964 cylinder barrel to replace one barrel in a 1962.
>
>
> Am I correct?
>
> Thanks
>  -- Doug Mackintosh
> Corsa member since 1996
> Corsa/NC member since 1996, Virtual Vairs member
> Corvair owner 1969-1971 and 1996-on
>  _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are the property
> of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America, http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs
>  _______________________________________________
>