<VV> Cutting a 2-1/6" hole in sheetmetal
Bob Tarpenning
bobtcars at wildblue.net
Tue Apr 10 08:56:44 EDT 2012
I have one of those. It works pretty good but you must have a good hold on
the drill when it breaks through. They tend to hang up and cause much
damage.
Bob T
-----Original Message-----
From: virtualvairs-bounces at corvair.org
[mailto:virtualvairs-bounces at corvair.org] On Behalf Of Matt Nall
Sent: Monday, April 09, 2012 5:55 PM
To: virtualvairs at corvair.org
Subject: Re: <VV> Cutting a 2-1/6" hole in sheetmetal
http://www.amazon.com/General-Tools-1-Inch-6-Inch-Accessory/dp/B00004T7P0
Matt Nall
Charleston, Oregon
http://tinyurl.com/The-Patio
http://tinyurl.com/Matts-Tech-Pages
_______________________________________________
This message was sent by the VirtualVairs mailing list, all copyrights are
the property of the writer, please attribute properly. For help,
mailto:vv-help at corvair.org This list sponsored by the Corvair Society of
America, http://www.corvair.org/ Post messages to: VirtualVairs at corvair.org
Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs
_______________________________________________
More information about the VirtualVairs
mailing list