<VV> advice and parts needed

[Mark Durham]

Ray, make sure you take the time to inspect those bearings. When I
pulled the axles on my 62 with 67k miles, the bearings were half worn
thru the races and were making no noise. Mark Durham

Sent from my Windows Phone
From: Ramon Rodriguez III
Sent: 5/7/2012 21:19
To: virtualvairs at corvair.org
Subject: Re: <VV> advice and parts needed
Thanks all for the advice on the wheel bearing problem.  Using the axles
from the 63 will be an inconvenience because the car is actually still
being used (until I have my 62 body ready to receive it's interior, engine,
etc.) so but I can make it work.

The plan is to steal the axles from my 62, put those in Ben's (assuming
they are good, haven't checked them but did drive the car a mile or two and
they sounded fine) and then when that body is ready swap the 63's onto it
along with tons of other stuff.

The 63 is very rusty underneath and I'm tired of dealing with it so I'm
using a good mostly rust free 62 coupe shell to rebody it.

Ray "Grymm" Rodriguez III
 _______________________________________________
This message was sent by the VirtualVairs mailing list, all copyrights
are the property
of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
This list sponsored by the Corvair Society of America, http://www.corvair.org/
Post messages to: VirtualVairs at corvair.org
Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs
 _______________________________________________