<VV> Windshield wiper switch access: '65 Monza convert

Harry Yarnell harryyarnell at verizon.net
Fri Aug 16 12:05:50 EDT 2013

Loosen the set screw on the knob and remove the knob. Next is a 9/16" (I
think) nut to remove, and the switch drops out the back. You could remove
the instrument cluster to gain some better access.

-----Original Message-----
From: virtualvairs-bounces at corvair.org
[mailto:virtualvairs-bounces at corvair.org] On Behalf Of John Westbrook
Sent: Friday, August 16, 2013 11:54 AM
To: virtualvairs at corvair.org
Subject: <VV> Windshield wiper switch access: '65 Monza convert

I'm troubleshooting my inop wipers.  I have voltage to one pin of the 2 spd
wiper motor but not the other.  Would like to gain access to the switch.
 Can anyone suggest the best way to get to the sw?  Is it possible to
partially drop the panel to reach the rear of the sw without removing the
steering wheel?

Many thanks,
John Westbrook
This message was sent by the VirtualVairs mailing list, all copyrights are
the property of the writer, please attribute properly. For help,
mailto:vv-help at corvair.org This list sponsored by the Corvair Society of
America, http://www.corvair.org/ Post messages to: VirtualVairs at corvair.org
Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs

More information about the VirtualVairs mailing list