<VV> strange?
Charles Cromwell
corvairguy2 at yahoo.com
Thu Dec 4 07:00:55 EST 2014
I have run into that several times over the years. I wondered about that toChuck
On Wednesday, December 3, 2014 9:08 PM, James Dunham via VirtualVairs <virtualvairs at corvair.org> wrote:
>
> The motor I am building now has 2 rods that were copper plated from
> skirt area to crank pin area, including the rod cap. I wonder why? must
> have been at factory? they came from a badly damaged (due to impact
> wrench abuse) RX block , 65 FC. Of course I have pictures.
> Regards, Tim Colson
> URL: <
> http://www.vv.corvair.org/pipermail/virtualvairs/attachments/20141203/c2e55490/attachment.jpe
> >
I believe that was done at the factory to tighten up tolerance on rods that
were barely out of spec.
James Dunham
_______________________________________________
This message was sent by the VirtualVairs mailing list, all copyrights are the property
of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
This list sponsored by the Corvair Society of America, http://www.corvair.org/
Post messages to: VirtualVairs at corvair.org
Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs
_______________________________________________
More information about the VirtualVairs
mailing list