<VV> Corvair heater "FAN" is a 4-speeds too (Off-Low-Med-Hi)

Charlie chaz at properproper.com
Mon Dec 8 12:52:58 EST 2014


OK - that makes sense of it all, with the resistor and all.

I'm trying to figure out the slide switch's internal contact arrangement to
complete the GM diagram.

Thanks guys!
Charlie


-----Original Message-----
From: VirtualVairs [mailto:virtualvairs-bounces at corvair.org] On Behalf Of
Matt Nall via VirtualVairs
Sent: Sunday, December 07, 2014 7:25 PM
To: virtualvairs at corvair.org
Subject: Re: <VV> '65 Corvair heater "FAN" selector has 4 settings?

OFF -  low fan / medium / high fan speed


Do you have voltage coming out of the resistor?    If fan is unplugged... no
load... you should still have 12 vdc.in easc position


Matt Nall
Charleston, Oregon
http://tinyurl.com/The-Corvair-Patio

http://tinyurl.com/Matts-Tech-Pages







-----Original Message-----
From: Charlie via VirtualVairs <virtualvairs at corvair.org>
To: 'Virtual Vairs' <virtualvairs at corvair.org>
Sent: Sun, Dec 7, 2014 7:19 pm
Subject: <VV> '65 Corvair heater "FAN" selector has 4 settings?


Still working on getting some heat in my 1965 Monza 110 4-speed convertible:

The Corvair heater "FAN" selector seems to have 4 "detents" for different
settings.

Assuming all the way up is "off," what does each "step" down accomplish?

I just refurbished the fan blower motor, removing a few spider nests and
what may have been the grisly end for a mouse.

The blower motor works (nice and quiet after greasing the shaft and removing
the grunge) 

Connecting it directly to battery and ground, it's OK, but not from the
controls on the dash.  

The resistor has 12V where it should but it seems not to get back to the
connector to the motor (back over the rear axle.)

I suspect the connector behind the dash that feeds the instrument lamps
(which do not light, but the "ALT" and "TEMP/PRESS" lights do work)

I'm trying to figure out the switch behind the heater controls while I'm at
it, hence the questions that may be a bit tangential, but I'm curious, and
it may be part of the problem?

Thanks!

Charlie

 _______________________________________________
This message was sent by the VirtualVairs mailing list, all copyrights are
the property of the writer, please attribute properly. For help,
mailto:vv-help at corvair.org This list sponsored by the Corvair Society of
America, http://www.corvair.org/ Post messages to: VirtualVairs at corvair.org
Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs
 _______________________________________________

 
 _______________________________________________
This message was sent by the VirtualVairs mailing list, all copyrights are
the property of the writer, please attribute properly. For help,
mailto:vv-help at corvair.org This list sponsored by the Corvair Society of
America, http://www.corvair.org/ Post messages to: VirtualVairs at corvair.org
Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs
 _______________________________________________



More information about the VirtualVairs mailing list