<VV> PG adjusting tool

[shortle]

I bought this tool from Clarks Corvair Parts. Very reasonably priced and a very good reproduced item IMO. And a very important adjustment as this can destroy the transmission if not done properly. Ask me how I know this. 
Timothy Shortle in Durango Colorado 81301 


-----Original Message-----
>From: N2VZD--- via VirtualVairs <virtualvairs at corvair.org>
>Sent: Jun 23, 2014 4:38 PM
>To: virtualvairs at corvair.org
>Subject: Re: <VV> PG adjusting tool
>
>I made some using 1/4 inch key stock and a roll pin cut off with a dremel.  
>works fine. I think I got dimensions from shop manual.
>If not I can dig it out and measure it later.
> 
>Regards, Tim Colson
> 
> 
> _______________________________________________
>This message was sent by the VirtualVairs mailing list, all copyrights are the property
>of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
>This list sponsored by the Corvair Society of America, http://www.corvair.org/
>Post messages to: VirtualVairs at corvair.org
>Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs
> _______________________________________________