<VV> 1965 BU wiring route

[Harry Yarnell (Verizon)]

The switch on the shifter is for an automatic.
The stick shift one has a two pin connector in the tunnel, but if you say
the wiring's messed up, well...


-----Original Message-----
From: virtualvairs-bounces at corvair.org
[mailto:virtualvairs-bounces at corvair.org] On Behalf Of Brian
Sent: Monday, March 03, 2014 7:22 PM
To: VirtualVairs at corvair.org
Subject: <VV> 1965 BU wiring route

Trying to help a fellow club member replace his BU switch.  Car came with
some hacked up wiring.  New switch from Clark's has wire that is too short
to route it as originsl owner had.  Assembly Manual Section 12 C6 shows some
switch set up that uses shifter.  Never saw anything like that on a car.
This switch does in fact go into the trans.  Anybody got a pix or diagram
showing correct routing?  I know there is cnnector in the tunnel. Thanks.
____________________________________________________________
Never Eat This Carb
Literally Never! 1 Easy Tip to Increase Fat Burning, Lower Blood Sugar
http://thirdpartyoffers.juno.com/TGL3131/53151ce3bbba61ce332d0st02vuc
 _______________________________________________
This message was sent by the VirtualVairs mailing list, all copyrights are
the property of the writer, please attribute properly. For help,
mailto:vv-help at corvair.org This list sponsored by the Corvair Society of
America, http://www.corvair.org/ Post messages to: VirtualVairs at corvair.org
Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs
 _______________________________________________