<VV> over size cyls EXPENSIVE?

[Paul Fox]

If the custom pistons are made correctly then no other machine work should need done. That is as long as you stick with the stock rods. That would make the price about $200 or so more than the VW set-up. The full fin design is probably worth that much extra because the VW cylinders sometimes split down the side. They look as though they may cool a little better too. 
Paul Fox  


On Tuesday, September 2, 2014 9:13 PM, Matt Nall via VirtualVairs <virtualvairs at corvair.org> wrote:
  





Cases have to be machined along with a LOT of other work to use this type  
of setup. Head openings also.
Get ready to spend the big bucks.
Regards, Tim Colson

============================================================================


Not really any more that   buying new cylinders and pistons!               It's done by several  Corvair Mechanic / specialty shops    


  At American-pi.com!   Ray Sedman


":Corvair Big Bore Kit. 3.1 L displacement!  Kit includes new, Cylinders, Pistons, Rings and reworked connecting rods. Includes machine work on con-rods, heads and case to fit larger cylinders. Customer supplies connecting rod cores, case and heads to be modified. $1575.00"
plus shipping to and from SoCal.



Matt Nall
Charleston, Oregon
http://tinyurl.com/The-Corvair-Patio

http://tinyurl.com/Matts-Tech-Pages











_______________________________________________
This message was sent by the VirtualVairs mailing list, all copyrights are the property
of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
This list sponsored by the Corvair Society of America, http://www.corvair.org/
Post messages to: VirtualVairs at corvair.org
Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs
_______________________________________________