<VV> LIFTER ADJUSTMNT

[MarK Durham]

When were the lifters manufactured?
Original equipment is 1 turn and that should last till engine overhaul.

Later gen lifters do not have as deep an area for the inner cup to move in
so 1/2 turn is standard adjustment.
Mark Durham
Hauser, ID
On Aug 26, 2015 4:35 PM, "Michael Kovacs via VirtualVairs" <
virtualvairs at corvair.org> wrote:

>  I have traditionally used 3/4 turn down after slack is taken up. I know
> the book says 1 turn. What is the current thinking? Advantages to 3/4 turns?
>  _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are
> the property
> of the writer, please attribute properly. For help, mailto:
> vv-help at corvair.org
> This list sponsored by the Corvair Society of America,
> http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options:
> http://www.vv.corvair.org/mailman/options/virtualvairs
>  _______________________________________________
>