<VV> [FC] Fc engine shroud fabric

[Jamison Hiner]

I used rivets, the "staples"were a pain
ᐧ

On Fri, Mar 13, 2015 at 1:35 PM, N2VZD--- via Corvanatics <
corvanatics at corvair.org> wrote:

> I used the correct fabric and .030 stainless wire to look like staples. I
> bought a roll of it years ago from Cotrofeld Automotive in VT. I think
> there
> are  pictures on the web of my methods.
> Regards, Tim Colson   CNYCC
> http://corvair.de/n2vzd/#engineshrouds
>
>
>
> In a message dated 3/13/2015 9:32:05 A.M. Eastern Daylight Time,
> corvanatics at corvair.org writes:
>
> Uh,  sorry about that subject line.  stupid auto correct.  thanks  again
>
> Mobile device...Have a great day!
>
> > On Mar 13, 2015, at  9:29 AM, Rod Murray <rmurray8996 at gmail.com> wrote:
> >
> > I'm  just about done with the engine installation on my 64 van can anyone
> share a  photo or information regarding the shroud fabric setup that runs
> along the  rear edge of the engine below the service door?
> > Many Thx.
> >
> > Rod
> > Restoration on a shoestring
> > Pittsburgh  3RC
> >
> >
> > Mobile device...Have a great  day!
> _______________________________________________
> Corvanatics mailing  list
> Corvanatics at corvair.org
> http://www.vv.corvair.org/mailman/listinfo/corvanatics
> This  list sponsored by the Corvair Society of America,
> http://www.corvair.org/
>
> _______________________________________________
> Corvanatics mailing list
> Corvanatics at corvair.org
> http://www.vv.corvair.org/mailman/listinfo/corvanatics
> This list sponsored by the Corvair Society of America,
> http://www.corvair.org/
>



-- 
Jamison Hiner

T: 402-203-5079
F: 402-551-9555

Honey Shiner <http://www.honeyshiner.com>
Red Rock Relish <http://www.redrockrelish.com>
JamisonHiner.com <http://www.JamisonHiner.com>

Contact Me [image: Linkedin] <http://www.linkedin.com/in/jhiner>[image:
Facebook] <http://www.facebook.com/jamisonhiner>[image: Flickr]
<http://www.flickr.com/photos/jamiedoug/>[image: Twitter]
<http://www.twitter.com/jamisonhiner>