<VV> dipstick tube

[Steve Gangi]

Thanks all, I'm getting a  correct size punch from the toolmaker at work and try to pop it out from the top. Already distorted the bottom end like Tim just said. 
Steve Gangi

----------------------------------------------------------------------

Message: 1
Date: Wed, 4 Sep 2019 16:20:07 +0000 (UTC)
From: N2VZD TIM <n2vzd at aol.com>
To: virtualvairs at corvair.org
Subject: Re: <VV> dipstick tube
Message-ID: <784619914.1506840.1567614007304 at mail.yahoo.com>
Content-Type: text/plain; charset=UTF-8



I have a punch that works good now from Harbor freight. It has a square ledge . It was a cheap set , @$8.00Before that I used one of my phillips screwdrivers from the bottom, carefully so tube does not cut into the handle. If you try a flat object on the bottom chances are you WILL add a bell at the bottom.? ?When building car motors , I usually end up putting a new tube in.Regards, Tim Colson? ? ? C N Y C C? ?