<VV> Clutch question

[Frank DuVal]

Right, difference is in length of ball stud.

Directions in Clark's Catalog:

https://ssl.corvair.com/user-cgi/catalog.cgi?show_page=108

Have you adjusted the Z bar first? aka clutch cross shaft.

Frank DuVal

On 7/15/2025 2:03 PM, GW via VirtualVairs wrote:
> Believe there is a difference in the pivot ball / stud for the throw out bearing clutch arm.
>
> Between early and late design.
>
> Thanks,
>
> Greg
>
>> On Jul 15, 2025, at 11:54 AM, Steve Gangi via VirtualVairs <virtualvairs at corvair.org> wrote:
>>
>> I've installed a 63 engine in a 64 convert. using the 63 flywheel, pressure plate and throw out bearing and a new clutch cable. I'm having trouble adjusting the clutch cable where it feels good. Car is still up on jackstands and haven't run the motor yet. Did I miss something? (while its still up in the air)
>> Steve GangiNew Haven, CT
>>
>>
>>