[FC] Inside filler panel

[Clark Hartzel]

Gas heater or hot air from motor heater?  If you are changing the blower
motor in back, you jack the vehicle up and get at it from the bottom.  No
need to pull floor panel.
Clark Hartzel

-----Original Message-----
From: corvanatics-admin@corvair.org
[mailto:corvanatics-admin@corvair.org]On Behalf Of Jeffrey Wells
Sent: Sunday, November 02, 2003 7:01 PM
To: corvanatics@corvair.org
Cc: virtualvairs@corvair.org
Subject: [FC] Inside filler panel


I'm replacing the heater motor in the Corvan this week (thanks for the
parts, Lon!).  I'm at the step where I'm removing the filler panel from
inside.  What size Phillips head screwdriver do I need?  The size looks
about 3 or so sizes bigger than anything that I have.
Is there anything that I should watch out for here?  I'm following the steps
in the '61 manual.

Jeff Wells
Blue Mountain/Lehigh Valley Corvair Clubs; CORSA, too
jfwells@ptd.net

'65 Monza
'64 Corvan "Hippie Power"
and other stuff



---
Outgoing mail is certified Virus Free.
Checked by AVG anti-virus system (http://www.grisoft.com).
Version: 6.0.532 / Virus Database: 326 - Release Date: 10/27/03
_______________________________________________
Corvanatics mailing list
Corvanatics@corvair.org
http://www.vv.corvair.org/mailman/listinfo/corvanatics
---
Incoming mail is certified Virus Free.
Checked by AVG anti-virus system (http://www.grisoft.com).
Version: 6.0.532 / Virus Database: 326 - Release Date: 27-Oct-03

---
Outgoing mail is certified Virus Free.
Checked by AVG anti-virus system (http://www.grisoft.com).
Version: 6.0.532 / Virus Database: 326 - Release Date: 27-Oct-03