[FC] SWAPPING 4-SPD.FOR AN AUTO.

[Keith Hammett]

What is the difference in PG?  Clarks lists the same PG for '61 to '65 FC.
Can you not use a 164 cuin engine on a '62 PG FC transmission?

Keith (hoping for no screw up) Hammett

-----Original Message-----
From: corvanatics-admin@corvair.org
[mailto:corvanatics-admin@corvair.org]On Behalf Of James Davis
Sent: Wednesday, September 03, 2003 10:32 PM
To: corvanatics@corvair.org
Subject: Re: [FC] SWAPPING 4-SPD.FOR AN AUTO.


Nothing on the engine but the bell housing needs to be changed.  Starters
are the same. There are two PG, before 64 and 64 and later.  The 64 and
later is for the 164 cuin engines.  All FC with PG had external coolers but
the a car PG can be made to work with an external cooler. .  You need a FC
transmission cross member (trans mount), torque convertor, flexplate and
flexplate bolts (different than manual).  Don't forget the shifter and
shift cable.  Dashes are the same.  There are a few clamps and screws you
will need.  I would see Howard R. about what you need.
Jim Davis

At 10:04 PM 9/3/2003 -0500, you wrote:
>Hi everyone,I have a 62 rampy that i would like to convert from a 4
>spd.to an auto.trans.I need to know what is involved?Same dash? will the
>carbs still work?starter?do i need different motor mounts and trans
>mounts?Does it have to be a F.C  only trans.Anyone have the parts in the
>middle TN.area? I tried to sell this truck without much luck,soooo i am
>thinking about giving to my wife (she has to have auto.) all replies
>appreciated
>Thanks    ,  Gary
_______________________________________________
Corvanatics mailing list
Corvanatics@corvair.org
http://www.vv.corvair.org/mailman/listinfo/corvanatics