[FC] deflashing heads....

[Merv and or Loretta]

It's an American Vermont drill bit that I bought from one of our local
(Salmon Arm pop 15,000) lumber yards (Rona), and the rod saw is a Stanley
brand that I purchased many years ago in Edmonton (a large city), I believe
from Beaver Lumber. It is made to fit in a hack saw frame and it can cut in
any direction. I plan to attach a couple of "handles" after passing one end
through the fins.
Merv
----- Original Message ----- 
From: "Williams, Rickie" <williamr@lindsey.edu>
To: <corvanatics@corvair.org>
Sent: Tuesday, February 10, 2004 4:18 AM
Subject: RE: [FC] deflashing heads....


> What I want to know is where can I buy the foot long 1/8 inch drill bit
and
> the 1/8 inch rod saw that you mention?  In this small town, those items
are
> unheard of...so preferably a source from the internet if you know of one.
>
> Thanks,
> Rickie Williams
> Columbia, KY
>
> > ----------
> > From: Merv and or Loretta[SMTP:krupross@sunwave.net]
> > Reply To: corvanatics@corvair.org
> > Sent: Monday, February 09, 2004 9:54 PM
> > To: corvanatics@corvair.org; corvairs@cybrus.net
> > Subject: [FC] deflashing heads....
> >
> > Hi all!
> >
> > Dropped the motor, put it on the bench, drained the oil, cleaned off a
> > bunch
> > of gunk, removed some shields, tipped it up on the bell housing end,
ready
> > to
> > take the rest of the shields off.
> >
> > Then I'm going in to deflash the heads. I bought a 1/8" x 12" drill bit,
> > and I
> > have a 1/8" rod saw to do the work.
> >
> > Any advice from those who have done this before....?
> >
> > Much obliged folks!
> >
> > Merv Krull
> > Salmon Arm
> > _______________________________________________
> > Corvanatics mailing list
> > Corvanatics@corvair.org
> > http://www.vv.corvair.org/mailman/listinfo/corvanatics
> _______________________________________________
> Corvanatics mailing list
> Corvanatics@corvair.org
> http://www.vv.corvair.org/mailman/listinfo/corvanatics