[FC] heater cables

[Merv and or Loretta]

Go Keith Go! <s>
Merv Krull
Salmon Arm


----- Original Message ----- 
From: "Keith Hammett" <khammett@stainlessfab.com>
To: <corvanatics@corvair.org>
Sent: Monday, February 16, 2004 6:55 AM
Subject: [FC] heater cables


> While working under the rampy this weekend I noticed that one of the
heater
> control cables was hanging loose on the rear of the rampy.  I went ahead
and
> installed the cable where it should have been, as I was doing so I
recalled
> that the PO mentioned that the heater was terrible.  Moving to the inside
of
> the truck I moved the selector and noticed that there was no tension on
the
> knob.  At closer inspection there are NO cables going to the heater
control.
> The two that run to the back have been cut off close to the floor.
>
> It looks as if I am in the market for new cables (or good used ones).  I
> will need all three.  Is there something I can pick up locally that will
> work?
>
> Front suspension is almost done.  Just need to pack wheel bearings, blast
> and paint drums and then install cross member in truck.  Hoping to have
this
> thing running in Spring!
>
> Thanks,
> Keith Hammett
> Springfield, Mo.
> _______________________________________________
> Corvanatics mailing list
> Corvanatics@corvair.org
> http://www.vv.corvair.org/mailman/listinfo/corvanatics