[FC] Screw for rear air outlet grille

[J R Read_HML]

Kent,  You should probably contact Larry Claypool.  I'm sure he could tell 
you what "Stock Is".

Attachments (if any) are scanned with anti-virus software.

Later, JR

----- Original Message ----- 
From: "Kent Sullivan" <kentsu at corvairkid.com>
To: "'The Corvanatics list'" <corvanatics at corvair.org>
Sent: Sunday, December 18, 2005 3:56 PM
Subject: [FC] Screw for rear air outlet grille


> Hi,
>
> I'm doing some research on these grilles. They exist on some years and
> models of FCs at the rear of the engine, below the bumper.
>
> If your rig has one of these grilles, could you please look at the six
> screws that hold it in? They should all be the same. I think they are hex
> head without a screwdriver slot.
>
> If the screws in your grille appear to be original, I would appreciate you
> removing one of them and sending me the following info (or send to the 
> list
> so that others don't duplicate):
>
> 1) Type of screw (I'm pretty sure they are sheet metal)
> 2) Size of head (5/16", 3/8", etc.)
> 3) Size of screw body (#8, #10, #12, etc.)
> 4) Length of screw (measured from underside of head to pointed tip)
> 5) Anything else notable, like if they are self-drilling
>
> Thanks,
>
> --Kent
>
>
> _______________________________________________
> Corvanatics mailing list
> Corvanatics at corvair.org
> http://www.vv.corvair.org/mailman/listinfo/corvanatics
> This list sponsored by the Corvair Society of America, 
> http://www.corvair.org/