[FC] Screw for rear air outlet grille

[Kent Sullivan]

Hi,

Before I emailed the list, I did check several FC assembly manuals. While
they give a part number, the drawing is so low-resolution that I could not
see the type of head or threads. 

--Kent
-----Original Message-----
From: corvanatics-bounces at corvair.org
[mailto:corvanatics-bounces at corvair.org] On Behalf Of N2VZD at aol.com
Sent: Monday, December 19, 2005 1:39 AM
To: corvanatics at corvair.org
Subject: Re: [FC] Screw for rear air outlet grille

oh yes different than early screws also...they are 5/16 i think.. i will
look later. now i have taken a hex head bolt type out of some also , but i
always thought they were "added". there are nuts welded on the body for
these to go into so no need for self tapping / drilling like cars.all my
early cars had a 
phillips self tapping/drilling (well pointed anyhow) about a number 8?
maybe 
early early like 60 or lakewood had something slightly different , cant
remember , and my lakewood is apart in the garage.  my assembly manuals are
in file cabs on my moving truck out in the snowdrift. they would show the
correct hardware.
regards, tim colson.
_______________________________________________
Corvanatics mailing list
Corvanatics at corvair.org
http://www.vv.corvair.org/mailman/listinfo/corvanatics
This list sponsored by the Corvair Society of America,
http://www.corvair.org/