[FC] fuel tank sender

[Keith Hammett]

On the fuel sender I don't know that you can "fix" them.  You can check it
with an ohm meter 0 - 45 ohm.  If bad you replace with a good used one (you
cannot buy new ones that I know of).  If you do want a new sender you can
get a universal one from Don's Sport shop.

On my stainless steel gas tank project I am putting in a new S/S pickup tube
and a new sender is attached to it.  I got it from Don's.  Everything is
custom on this...

Keith Hammett

-----Original Message-----
From: corvanatics-bounces at corvair.org
[mailto:corvanatics-bounces at corvair.org]On Behalf Of Wild8bill at aol.com
Sent: Wednesday, June 29, 2005 11:50 AM
To: corvanatics at corvair.org
Subject: [FC] fuel tank sender


What's the standard procedure to fix the fuel gauge sender? What should I
check first...last? Also, with my speedo, the inner piece of the cable is
spinning when the motor runs, the speedo needle moves when I spin the insert
a little
bit with my finger; but when I attach the cable the speedo still doesn't
work. Any tips? Almost done with the Rampside for Hot August Nights; then I
can
start maintaining the 'Brier (long neglected and shooting smoke until it
warms
up).
_______________________________________________
Corvanatics mailing list
Corvanatics at corvair.org
http://www.vv.corvair.org/mailman/listinfo/corvanatics
This list sponsored by the Corvair Society of America,
http://www.corvair.org/