[FC] FC Engine Seal

[Keith Hammett]

When I did my FC Engine seal I used small bolts and nuts to secure the
rubber strip.  Was easy to do and looks good.  Should be easy to do next
time as well.

Keith Hammett

-----Original Message-----
From: corvanatics-bounces at corvair.org
[mailto:corvanatics-bounces at corvair.org]On Behalf Of Bill Wells
Sent: Wednesday, May 25, 2005 12:02 PM
To: westerncanadacorsa at shaw.ca; The Corvanatics list
Subject: Re: [FC] FC Engine Seal


Joel,

I purchased one for a '73 transporter. It fits and is easy to install, but
is ugly. It is an "H" shaped foam strip.
I went ahead and used stainless wire to secure the original type rubber and
it looks great.

Good luck anyway you go.

Bill Wells

Western Canada CORSA <westerncanadacorsa at shaw.ca> wrote:
It's my understanding that there is a VW engine seal that is a great
replacement for the stock EM corvair part(s). Of course, not having owned
an FC until recently, I never paid much attention as to what VW it was
originally from. Anybody know what I should be asking for at the local
veedub parts store?

Regards,
Joel
_______________________________________________
Corvanatics mailing list
Corvanatics at corvair.org
http://www.vv.corvair.org/mailman/listinfo/corvanatics
This list sponsored by the Corvair Society of America,
http://www.corvair.org/


---------------------------------
Do you Yahoo!?
 Yahoo! Mail - Helps protect you from nasty viruses.
_______________________________________________
Corvanatics mailing list
Corvanatics at corvair.org
http://www.vv.corvair.org/mailman/listinfo/corvanatics
This list sponsored by the Corvair Society of America,
http://www.corvair.org/