[FC] Brake Tubing Bending

[Bill Wells]

First:
 
Who are you? Kind of hard to respond without a name.
 
Second:
The factory didn't use a single long piece either. There is a coupler along the bulkhead just behind the gas tank. From there it goes to the rear junction block. Use a piece of pipe of the radius you need for the bend. 1/2 inch watewr pipe works well. I don't know how tight a radius the line will allow.
 
Good Luck,
Bill Wells

Office 2004 Test Drive User <hauppauge21 at comcast.net> wrote:
The simple ;o( complete updating to a dual MC has become a nightmare. I
can't find a tubing bender that can replicate the tight radius bends of the
hard lines. Would making a form with finishing nails work? Would it fatigue
the metal? And, I can't find a straight hard line that's approx 75" long
for the under the bed line.
ANY SUGGESTIONS ??


_______________________________________________
Corvanatics mailing list
Corvanatics at corvair.org
http://www.vv.corvair.org/mailman/listinfo/corvanatics
This list sponsored by the Corvair Society of America, http://www.corvair.org/

		
---------------------------------
 Yahoo! FareChase - Search multiple travel sites in one click.