[FC] Re: Blower Relay

[Merv Krull]

still the old fan.... but I worked it over to balance it better...

thinking... if you used three relays and rewired the switch so that there is 
only one wire per setting and placed an appropriate resistor between the 
relays and the blower...

must be an easier way!
toodles
Merv


----- Original Message ----- 
From: <jcorvair at telus.net>
To: "Merv Krull" <krupross at sunwave.net>
Sent: Tuesday, June 12, 2007 1:01 PM
Subject: Re: Blower Relay


> Hi Merv,
>
> I know there is a way to wire the relay and maintain the three speeds.  It 
> is
> described in the tech guide I think, but I have never know  anyone to do 
> it.  I
> will pick up a relay some day or wait for my harness to burn out and then
> replace the wiring and put in a relay at the same time.
>
> Are you running the plastic fan?  As it was still available from GM a 
> couple
> years ago I put a new one on my new high volume motor and it sure is nice.
>
> Cheers,
>
> James
>
>
>
> Quoting Merv Krull <krupross at sunwave.net>:
>
>> Thats the problem.... only on or off... no three speeds now... high 
>> only...
>> but it sure blew the dust out of the ductwork!
>> I figure that since the blower is way in the back and I pretty much cant 
>> hear
>> it anyway, it can be on high whenever I need extra heat or defrost... not
>> stock... oh well
>> The diring wiregram is printed on the back of the package the relay comes 
>> in.
>> Ground, switching source, power, device
>> I mounted it under the cross bar I fabbed to mount the air management 
>> system
>> on (instead of the floor panel... again not stock... oh my!)
>> toodles
>> Merv
>>   ----- Original Message ----- 
>>   From: James Hogarth
>>   To: Merv Krull and or Loretta Prosser
>>   Sent: Monday, June 11, 2007 9:41 PM
>>   Subject: Blower Relay
>>
>>
>>   Hey Merv,
>>
>>
>>
>>   How did you wire the Relay for the blower?  I have been thinking of 
>> putting
>> a relay in just for safety sake, but wasn't sure how to wire it in so I 
>> had
>> the three speeds.
>>
>>
>>
>>   Cheers,
>>
>>
>>
>>   James Hogarth
>>
>>
>>
>>   CORSA Western Division Director
>>
>>   11719 Cottonwood Drive
>>
>>   Maple Ridge, B.C.
>>
>>   V2X 7Z3
>>
>>   604-476-1434 (Res.)
>>
>>   604-986-8551 (Bus.)
>>
>>   jcorvair at telus.net
>>
>>
>>
>
>
>
>