[FC] wahoo! clutch works fine!

[David C. Herrin III]

How about some pictures of my FC Clutch Cable installed ?
I built in adjustments - at both ends of the cable assembly.
I have used the old mounts and recently had to fabricate some from angle
iron.
David

> figure out why it would not go into gear after installing new Dale
> flywheel/PP/Disk/release bearing and new clutch cable from The Source.
>
> Well, inspiration made it all too easy. I realized the clutch rod was
> simply not pulling far enough and I had run out of adjustment room.
>
> I flipped the bracket I fabricated for the front end of the new cable
> and decided that is where it needed to be. I fabricated a new bracket
> accordingly, moving it about 1.5 inches further away from the clutch
> pedal pin, and Voila!
>
> If felt right. I could feel the 'overcentre' point very clearly.


-----------------------------------------
This email was sent using AIS WebMail.
http://www.americanis.net/