[FC] space saver spare

[Gary Swiatowy]

My space saver sits about 2 inches over the step.
So I have to tighten it while holding it up.
I have it mounted "dish" inward.
And there is a large washer (5")and I go through one of the lug holes.
Gary Swiatowy

-----Original Message-----
From: corvanatics-bounces at corvair.org
[mailto:corvanatics-bounces at corvair.org] On Behalf Of Allen Kidd
Sent: Thursday, August 26, 2010 1:19 PM
To: corvanatics at corvair.org
Subject: [FC] space saver spare

For those that have switched to a space saver, how did you mount it to
the wall of the van?  Ive got one from a mid 80's caprice which is the
correct bolt pattern but when I mount it inside the van it sits about
half an inch off the step beside the engine cover.  The factory rod &
wing nut wont go all the way in to hold it tight.  Did you make your
own shorter holder or just cut down the original
_______________________________________________
Corvanatics mailing list
Corvanatics at corvair.org
http://www.vv.corvair.org/mailman/listinfo/corvanatics
This list sponsored by the Corvair Society of America,
http://www.corvair.org/