[FC] Need MuseumBrier table Suggestions

[Rod Murray]

In a word, yeah!  :)

Rod
64 GB (currently sans table)

-----Original Message-----
From: corvanatics-bounces at corvair.org [mailto:corvanatics-bounces at corvair.org] On Behalf Of Bryan Blackwell
Sent: Friday, March 05, 2010 9:02 AM
To: Vairtec Corporation
Cc: corvanatics Membership
Subject: Re: [FC] Need MuseumBrier table Suggestions

Perhaps you could post those measurements and take a couple photos for any other interested parties too :-)

--Bryan

On Mar 5, 2010, at 11:41 AM, Vairtec Corporation wrote:

> Easy answer:  When you are here this weekend, we will use the 
> factory-original table in my '64 Greenbrier to make a template for you 
> to cut a new table out of a sheet of plywood or laminated countertop 
> material or whatever you choose.  The legs and hardware are still 
> duplicate-able today using standard hardware store (or McMaster-Carr) 
> pieces.  We can take some measurements in my van so that you can install 
> your repro table right where the factory would have.

_______________________________________________
Corvanatics mailing list
Corvanatics at corvair.org
http://www.vv.corvair.org/mailman/listinfo/corvanatics
This list sponsored by the Corvair Society of America, http://www.corvair.org/