[FC] Bench seat on a Rampside

[J. R. Read]

There is no backing OR latch on my Rampside seatback.
Later, JR
----- Original Message ----- 
From: "Fred Adler" <fadler at genbio.com>
To: <corvanatics at corvair.org>
Sent: Wednesday, April 23, 2014 3:30 PM
Subject: [FC] Bench seat on a Rampside


>I have new vinyl seat covers and foam and am reupholstering the front bench 
>seat on my Rampside.  Two questions:
>
>
> 1.       The prior seat cover was not stock and they had some sheet 
> aluminum screwed to the back of the bench seat.  The new seat cover will 
> cover the back but when I dismantle the old, the sheet aluminum comes off 
> and is obviously not stock.  The back of the seat is framed but do I put 
> something like Masonite or cardboard across the back prior to recover or 
> just slip on seat cover over the seat wide frame?
>
> 2.       Was there a "lock" or "lever" to release the front bench to fold 
> forward.  There is none now and there are holes but is there a locking 
> mechanism to keep the seat from just folding forward?
>
> Thanks,
>
> Fred Adler
> San Diego
> _______________________________________________
> Corvanatics mailing list
> Corvanatics at corvair.org
> http://www.vv.corvair.org/mailman/listinfo/corvanatics
> This list sponsored by the Corvair Society of America, 
> http://www.corvair.org/ 


---
This email is free from viruses and malware because avast! Antivirus protection is active.
http://www.avast.com