[FC] electrical gremlin

[Bryan Blackwell]

Hi Tim,

I haven't seen a specific answer, but if you have good brake lights, then the grounds and power feed to the back is ok.  If it's just the turn signals that are having this problem, the I'd start with the turn signal switch.

--Bryan

> On Nov 24, 2015, at 12:13 PM, wern3--- via Corvanatics <corvanatics at corvair.org> wrote:
> 
> I am going to try to sort out an electrical gremlin on Rampy that just cropped up. When the turn signal is to my right the front and rear lights flash correctly;...all is well. When turning to the left, the initial signal is bright and then dims until the bulb's filament is only seen to be orange-yellow when the red lens is removed. I removed the rear lens and checked the ground by using copper wire on a known clean frame contact.Next I assume I should  look under the dash at that little switch box which is connected to the lever by a cable? right?Tim 61 Rampy 140 4 spd.