[NoVa-Corvairs] March Meeting

[Darrin Hartzler]

Hi Jason,

If you have all the bits, I am pretty sure we can do the conversion.  It 
is dead simple on a car...drill a hole, connect some lines and bolt it up. 
 Never done it on a van, but likely similar I guess.

Have plenty of fluid if we are changing the MC though.

LD is right, please soak all the hardward we need to loosen with PB 
Blaster!

Darrin


____________________________________________________________________________________________
Darrin R. Hartzler
Manager, Corporate Governance Unit
Department of Corporate Advice
International Finance Corporation
Washington, DC
Phone: +1-202-473-0027
Office: F3P-118
e-mail: dhartzler at ifc.org




37fingers73 at comcast.net 
Sent by: novacc-list-bounces at corvair.org
03/07/2009 10:25 AM
Please respond to
Northern Va Corvair Club <novacc-list at corvair.org>


To
novacc-list at corvair.org
cc

Subject
[NoVa-Corvairs] March Meeting






Hello everyone,

I am thinking of ideas for the March 21st meeting that I will be hosting 
here in Dale City. 
I still need to correct the problem of a hard pulling to the right when I 
brake. I have the two front brake hoses and brake fluid. Are there any 
special tools that I would need? 
Is it feasible that we could change my single master cylinder to a dual in 
the time we will have?

On a side note, recently I had the Clark's single exhaust kit installed on 
my Greenbrier and was amazed at how quiet it sounded. 

-Jason 


_______________________________________________
Novacc-list mailing list
Novacc-list at corvair.org
http://www.vv.corvair.org/mailman/listinfo/novacc-list