[NoVa-Corvairs] Rocker Panel Moulding

[Bryan Blackwell]

Hi Curt,

Coincidentally, we (Stefan and I) took off that same trim from our '66 for the same reason.  There is a long bracket U shaped bracket screwed onto the car, the trim hooks over the top then snaps down.  To get it off I usually find a soft mallet is required to get it started.  Hope that helps.

--Bryan

On Feb 7, 2012, at 12:03 PM, clshimp at q.com wrote:

> 
> 
> Members:  I need a little advice.  Almost 50 years with Corvairs and I have never taken the rocker panel molding strip off a Corvair.  Getting my '66 ready for a paint job and took the 2 screws out of the molding.  I am sure there are a couple of retaining clips holding the molding on but don't want to start prying away and break anything.  Do you pry up from the bottom edge, the top, or both?  Does it need a lot of force? 
> 
>   
> 
> I found nothing on this in the "assembly" manual nor illustrations in Clark's.  Curt 
> _______________________________________________
> Novacc-list mailing list
> Novacc-list at corvair.org
> http://www.vv.corvair.org/mailman/listinfo/novacc-list