[NoVa-Corvairs] Noob May Need a Good Used Head

[Vernon Welsted]

Dan,
If you're just removing the driver's head you don't need to remove the top shroud.
Vernon

Sent from my iPhone

> On Mar 7, 2017, at 10:26 AM, Dan Weiss via Novacc-list <novacc-list at corvair.org> wrote:
> 
> I just dove into the underside to get the head number and did plan to use the manual for the top side.  Mine is a 65 manual.  Should be the same procedure?
> 
> Dan
> 
> Sent from my Verizon Wireless 4G LTE Droid
>> On Mar 7, 2017 10:02 AM, Bryan Blackwell via Novacc-list <novacc-list at corvair.org> wrote:
>> 
>> Remove the top shroud and side shroud.  You are following the shop manual procedure, correct? 
>> 
>> --Bryan 
>> 
>>> On Mar 6, 2017, at 6:09 PM, Dan Weiss <dkakd at aol.com> wrote: 
>>> 
>>> I cannot for the life of me figure out how to remove the heater hose shroud that was hiding the number.  I removed the bottom corner bolt and the bolt inside the housing, but there does not seem enough clearance for either a ratchet or box end wrench.  Any tips?  
>>> 
>> 
>> _______________________________________________ 
>> Novacc-list mailing list 
>> Novacc-list at corvair.org 
>> http://www.vv.corvair.org/mailman/listinfo/novacc-list 
> _______________________________________________
> Novacc-list mailing list
> Novacc-list at corvair.org
> http://www.vv.corvair.org/mailman/listinfo/novacc-list