[V8Vairs] Instructions For Installing Clutch Master CylinderAtMidpoint On Firewall

[Rick & Janet Norris]

Dave,
I am using a McLeod hydraulic throwout bearing with a 1" Tilton master 
cylinder. My clutch is a Centerforce also.

Rick



> Rick:
> Thanks for the help.I notice it looks like you have
> used a Tillotson Master Cylinder on your clutch set up
> - what bore did you go with 3/4" or 7/8". I had used
> 3/4 " bore utilizing a MC from an import car- it did
> not seem to develop eough fluid push to actuate the
> clutch. I am using with a Center Force mid range cluth
> coupled with a Howe Throwout Bearing/Slave Cylinder.
> Thx,
> Dave Nezda
>
> --- Rick & Janet Norris <rickjanet at charter.net> wrote:
>
>>
>> Dave,
>> Check out my set up at:
>> http://www.corvaircorsa.com/norris08.html#3
>>
>> http://www.corvaircorsa.com/norris06.html#1
>>
>> >I am inquiring if anyone has instructions for
>> > installing the clutch master cylinder to the right
>> of
>> > the throttle approximately  1/3 to 1/2 ( or near
>> > centerline on firewall )> have seen written
>> > instruections but not recall where it was that I
>> read
>> > about it. Please have member respond by e-mail.
>> > Thanks,
>> > Dave Nezda
>> _______________________________________________
>> V8Vairs mailing list
>> V8Vairs at corvair.org
>> http://www.vv.corvair.org/mailman/listinfo/v8vairs
>> This list sponsored by the Corvair Society of
>> America, http://www.corvair.org/
>>
>
> _______________________________________________
> V8Vairs mailing list
> V8Vairs at corvair.org
> http://www.vv.corvair.org/mailman/listinfo/v8vairs
> This list sponsored by the Corvair Society of America, 
> http://www.corvair.org/
>