[V8Vairs] Help on bellhousing Dust Cover Part No.

[v8vairs@corvair.org]

I used a '62 pickup bellhousing on a Jeep project years ago.  The '62 
model year was the only one that did use a slave cylinder, all others had 
conventional drivers side mechanical linkage.  If I remember correctly, 
this is a big, heavy cast iron housing that looks like the bottom half was 
sawn off.  I believe that the dust cover was however not unique to that MY 
bellhousing, but was the same as other cast iron bellhousing covers.  You 
might try LM truck.  They have reproduction parts for all Chevy pickups 
from '49 to '72.





GnKHOFFMAN 
Sent by: v8vairs-admin@corvair.org
02/08/2005 05:50 PM
Please respond to
v8vairs@corvair.org


To
v8vairs@corvair.org
cc

Subject
[V8Vairs] Help on bellhousing Dust Cover Part No.






Guys:

I am looking for a new bellhousing dust cover;  I have been told 
(accurate? 
or not?) that the bellhousing I have is from an early Pickup, as it has 
the 
holes needed to bolt in the slave clutch cylinder.

I need a new rubber dust cover (the old one is crumbling!).  It is 
rectangular in shape, measuring approximately 2.5" x 5.25";  Carquest 
doesn't list a 
part number for early 60's pickups.

Does anyone know a part number (and/or year) I should be asking for?  Does 

anyone know if it really is a Pickup bellhousing?

Thanks for any suggestions!

Gary Hoffman
_______________________________________________
V8Vairs mailing list
V8Vairs@corvair.org
http://www.vv.corvair.org/mailman/listinfo/v8vairs
This list sponsored by the Corvair Society of America, 
http://www.corvair.org/