[V8Vairs] looking for Crown parts

[PatioMatt at aol.com]

In a message dated 10/3/2006 6:28:25 PM Pacific Daylight Time, 
macman327 at yahoo.com writes:

> I can make good power with leg room with 4.3 v-6. I've
> got the heavy duty 914 transaxle but I don't think I
> could hook it up to my Corvair axles... or the kits
> are too much $$ It's complete too. 1973 side shifter
> with full shifting rod and axles.. got a few of these
> transaxles
-------------------------------------------------------------------------

Adapting to Vair shafts is no problem...I believe someone sold U-joint to CV 
flanges for awhile....the opposite is easy for any shop to do.

Many feel the VW / Porsche diff. side bearings are not strong enough to act 
as upper control arms...but the ones I've seen are huge!

www.kennedyeng.com  makes the engine adapters.....might know about CV 
adapters as well..

Matt