[V8Vairs] GM TPI question

[vairmech at aol.com]

  How about getting an old speed sensor that goes in the speedo cable for the old style cruise control? That will give you the signal that you want.
 Ken Hand
    
 -----Original Message-----
 From: bubblehd at excite.com
 To: V8Vairs at corvair.org
 Sent: Sun, 11 Feb 2007 10:25 PM
 Subject: [V8Vairs] GM TPI question
 
  
I'm looking at the possibility of replacing my Edelbrock Performer and 4160 carb 
with a GM TPI set-up. I've been doing some research on the conversion, and the 
only problem I see is with the Vehicle Speed Sensor (VSS). From what I see, this 
is a critical requirement to have the ECM function properly. The question I 
have, is; where, on a Crown drivetrain, can I install a VSS? From what I've 
read, the normal location is at the output of the transmission, obviously 
difficult to do on the Crown.




_______________________________________________
Join Excite! - http://www.excite.com
The most personalized portal on the Web!


_______________________________________________
V8Vairs mailing list
V8Vairs at corvair.org
http://www.vv.corvair.org/mailman/listinfo/v8vairs
This list sponsored by the Corvair Society of America, http://www.corvair.org/
   
________________________________________________________________________
Check out the new AOL.  Most comprehensive set of free safety and security tools, free access to millions of high-quality videos from across the web, free AOL Mail and more.