[V8Vairs] Kelmark shift linkage

[wayback]

Bruce,  I have my original (circa 1975) Kelmark Instruction Manual.  If 
it might be of some assistance, I can try to scan bits of it for you.  
Let me know and tell me where you want it sent.

Don Prusha  327, ZF


On Nov 12, 2007, at 7:20 PM, Bruce wrote:

> I am trying to understand how to install the shift linkage for a 
> Kelmark V-8 Vair.  I purchased a used kit removed from another Corvair 
> that included the shift linkage.  Here is a link to a photo of that 
> linkage.
>
> http://www.chevelles.com/showroom/data/500/medium/66_V8-Vair_021.jpg
>
> I suspect this is not as Kelmark intended it, after doing my best to 
> understand the Kelmark installation instructions.  The rear connection 
> to the transmission is not a problem, and I think the front shifter 
> handle part is probably a Kelmark piece, but the center looks to me 
> like a steering shaft and support that has been incorporated.  The 
> support only rotates and does not allow the shaft to move forward and 
> backward.  I don't see a support for the front of the shifter,
>
> Does this look correct?  I would have thought the OEM shifter tube 
> would have been used in some way.  What handle did Kelmark use on the 
> shifter?
>
> Please comment on the parts that I have and help me understand what an 
> original Kelmark setup should like and how to install it.  Thanks
>
> Bruce
> _______________________________________________
> V8Vairs mailing list
> V8Vairs at corvair.org
> http://www.vv.corvair.org/mailman/listinfo/v8vairs
> This list sponsored by the Corvair Society of America, 
> http://www.corvair.org/
>