[V8Vairs] Who has the most recently started V-8 conversion?

[TNT Automotive]

I started my project with a 66 monza 140 that I bought for a dollar in 1998. 
I bought a parts car for $400.00 in 2000. Installed a 5.3 engine in 2005 out 
of a 2003 chev 1/2 ton with all the factory efi, (wish i had gone for a 
carb.it might be done by now!). Built all the adapters and such from bits 
and pieces of different vehicles. Currently it is a running chassis with all 
the final body work left 2 B done. I am currently looking 4 motivation 
(these E mails keep me interested, Thanx).

----- Original Message ----- 
From: "Thomas, Robert R Civ USAF AFMC 76 PMXG/OBPE" 
<Robert.Thomas at tinker.af.mil>
To: "discussion of non-stock engines in Corvairs" <v8vairs at corvair.org>
Sent: Friday, September 10, 2010 9:58 AM
Subject: Re: [V8Vairs] Who has the most recently started V-8 conversion?


>I began seriously a couple of years ago. It's a Crown with a SBC. I've
> collected about all of the parts with great advice from Mike Levine. I'm
> starting to assemble the parts into a car. It's going much slower than
> I'd like but should accelerate now that my wife and I are alone with the
> dogs.
>
> I'm using original Crown parts with no modern changes. I'm having enough
> trouble getting things going without delays caused by innovation. Mike's
> Crown car is a superb race car with Crown and Corvair parts and I hope
> to build a similar, if slower and much less powerful, car.
>
>
> Bob Thomas 68 Monza
> _______________________________________________
> V8Vairs mailing list
> V8Vairs at corvair.org
> http://www.vv.corvair.org/mailman/listinfo/v8vairs
> This list sponsored by the Corvair Society of America, 
> http://www.corvair.org/