[V8Vairs] Rear Strut Rods

[Ken Hand]

I have available lower strut rods with urethane bushings, greasable, and a direct bolt in. These are Aluminum rod with steel ends. I think they are a little more money than the Vette ones but way lighter.

 

 

Ken Hand
Handy Car Care
248-613-8586
www.corvairmechanic.com

http://s186.photobucket.com/albums/x118/vairmech/Viet%20Nam%20Pictures%201971/


 

 

-----Original Message-----
From: Gord Rexin <gorexin at shaw.ca>
To: v8vairs <v8vairs at corvair.org>
Sent: Sun, Sep 7, 2014 12:04 am
Subject: [V8Vairs] Rear Strut Rods


Looking for opinions on replacing stock strut rods with 84- 96 Corvette 
adjustables. Most of the info I found is a couple years old, anyone know how 
well they hold up? I thought of heim joints but it sounds like they wear fast. 
On a side note I replaced my worn out Ford steering rack with a NAPA 
replacement, had to trim 1.25 inches off each tie rod. Will put the tie rod ends 
on tomorrow. When my wife gets back with the camera, I'll take some shots.
Gord
_______________________________________________
V8Vairs mailing list
V8Vairs at corvair.org
http://www.vv.corvair.org/mailman/listinfo/v8vairs
This list sponsored by the Corvair Society of America, http://www.corvair.org/