[V8Vairs] Rear Strut Rods

[Gord Rexin]

Sent PM on your website Ken.
Gord
On 2014-09-07, at 5:17 AM, Ken Hand wrote:

> I have available lower strut rods with urethane bushings, greasable, and a direct bolt in. These are Aluminum rod with steel ends. I think they are a little more money than the Vette ones but way lighter.
> 
> 
> 
> 
> 
> Ken Hand
> Handy Car Care
> 248-613-8586
> www.corvairmechanic.com
> 
> http://s186.photobucket.com/albums/x118/vairmech/Viet%20Nam%20Pictures%201971/
> 
> 
> 
> 
> 
> 
> -----Original Message-----
> From: Gord Rexin <gorexin at shaw.ca>
> To: v8vairs <v8vairs at corvair.org>
> Sent: Sun, Sep 7, 2014 12:04 am
> Subject: [V8Vairs] Rear Strut Rods
> 
> 
> Looking for opinions on replacing stock strut rods with 84- 96 Corvette 
> adjustables. Most of the info I found is a couple years old, anyone know how 
> well they hold up? I thought of heim joints but it sounds like they wear fast. 
> On a side note I replaced my worn out Ford steering rack with a NAPA 
> replacement, had to trim 1.25 inches off each tie rod. Will put the tie rod ends 
> on tomorrow. When my wife gets back with the camera, I'll take some shots.
> Gord
> _______________________________________________
> V8Vairs mailing list
> V8Vairs at corvair.org
> http://www.vv.corvair.org/mailman/listinfo/v8vairs
> This list sponsored by the Corvair Society of America, http://www.corvair.org/
> 
> 
> _______________________________________________
> V8Vairs mailing list
> V8Vairs at corvair.org
> http://www.vv.corvair.org/mailman/listinfo/v8vairs
> This list sponsored by the Corvair Society of America, http://www.corvair.org/