<VV> crankcase vent on individual air cleaners

[Joe Robbins]

Some fix that is. Where's the duct tape and baling wire? 
Joe Robbins
AHMFIC 
BBRT


-----Original Message-----
From: virtualvairs-admin@corvair.org [mailto:virtualvairs-admin@corvair.org]
On Behalf Of Louis C. Armer, Jr.
Sent: Saturday, April 03, 2004 8:09 PM
To: virtualvairs@corvair.org
Cc: Marc Sheridan
Subject: Re: <VV> crankcase vent on individual air cleaners

It's simple. Just use a plastic in-line reducer connector and push it right 
in on
both hoses.

Chuck Armer
///////////////////////////////
At 07:53 PM 4/3/04 -0500, you wrote:
>I recently purchased the little chrome air cleaners from Clarks with the
>fittings to connect the crankcase vent to on of them. The kit comes with a
>barbed fitting that fits a 3/8" ID hose. However the crankcase vent tube is
>7/16" OD (?).
>
>I have ideas on how to make the connection, but I'm  curious to hear how
>some of you have hooked yours up and I know some of  you have these same
>filters, because Clarks had them on backorder for a time before I could get
>mine.
>
>One of the options I have pondered is to use a compression fitting on the
>vent tube and somehow integrate a barb fitting for the 3/8" ID hose.
>Comments and suggestions are most welcome and appreciated.
>
>Marc Sheridan
>'66 Monza 'vert 110/4
////////////////////////////////////////////////////////////////////////////
///// 


Corvair Atlanta, BOD
CORSA MEMBER
CORSA Tri-Membership Chairman
http://carmerjr.home.mindspring.com/  
_______________________________________________
This message was sent by the VirtualVairs mailing list, all copyrights are
the property
of the writer, please attribute properly. For help,
mailto:vv-help@corvair.org
This list sponsored by the Corvair Society of America,
http://www.corvair.org/
Post messages to: VirtualVairs@corvair.org
List info: http://www.vv.corvair.org/mailman/listinfo/virtualvairs