<VV> Synthetic Oil again
BobHelt@aol.com
BobHelt@aol.com
Fri, 9 Apr 2004 01:48:27 EDT
In a message dated 4/8/04 10:24:19 PM US Mountain Standard Time,
cmzaustin1@netscape.net writes:
> 1) Is the "break in period" defined as 1000 miles, or 3000 miles, or
> some other number, or is there something about the functioning of the
> car that would tell me the engine is fully broken in?
>
Break in lasts until the rings seat. That is usually determined by the amount
of oil the engine uses. Prior to seating, oil consumption is higher than
after.
If your cylinders were really round and taper free, then the type of honing
that was done will probably determine then this happens. If your cylinders were
plateau honed, the breakin will be almost immediate. Then your first
consideration should be with the cam and lifters. Run the eng at 2000 rpm for 20
minutes when first started to accomplish this. Also use a cam oil supplement for
the cam if new.
Regards,
Bob Helt