<VV> Piston Damage from Guide Fragments?

[Roger Gault]

I agree, but be sure to roll a ring around the groove to be sure the groove
is not crushed.  If the ring is grabbed, I'd be nervous about using the
piston.

Roger

----- Original Message ----- 
From: <EUGENE1938@aol.com>
To: <pottsf@msn.com>; <virtualvairs@skiblack.com>
Sent: Saturday, August 14, 2004 4:49 PM
Subject: Re: <VV> Piston Damage from Guide Fragments?


> pottsf@msn.com writes:
> I'd like to know what people think of my continuing on
> with the pistons.
>
> Joe,
> Clean the piston tops with a brush on a bench grinder then
> with a hammer gently tap the high/pointed spots down to
> eliminate them.  There will still be some low spots but ignore
> them.  They will eventually fill up with carbon.  Go ahead and
> use the pistons.
>
> Ed Corson (CORSA member)
> IECC - Riverside, CA
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are
the property
> of the writer, please attribute properly. For help,
mailto:vv-help@corvair.org
> This list sponsored by the Corvair Society of America,
http://www.corvair.org/
> Post messages to: VirtualVairs@corvair.org
> List info: http://www.vv.corvair.org/mailman/listinfo/virtualvairs
> _______________________________________________