<VV> 'shift kits'

[Sadek Charles H DLVA]

Harry,
Your mind is good enough.  You are right about the 3 spd, etc. If anyone
does this, make sure the slot on top, if not symmetrical side-to side; one
edge may be lower than the other, allows reverse on a 4 spd to be engaged.

Chuck S

-----Original Message-----
From: Harry Yarnell [mailto:hyarnell1@earthlink.net] 
Sent: Friday, December 10, 2004 11:05 AM
To: Bill Elliott; RKAT; virtualvairs@corvair.org
Subject: Re: <VV> 'shift kits'

The three speed floor shifter base was taller. By maybe an 1". It's a
readily visable difference.
I remember years ago (30?) something about switching 3 speed-4 speed bases
around with the shift lever pivot pressed further up the shaft to reduce the
shift throw. But my mind isn't any good anymore.

Harry Yarnell
perryman garage and orphanage
perryman, MD
hyarnell1@earthlink.net